Ohm meter
08 April, 2009 | Supplied by: Westek Electronics Pty Ltd
The KoCoS Promet 100 Precision Ohm meter is suited to tasks including earth bond and weld testing, as well as circuit breaker main contact testing. The device interfaces with the KoCoS range of ACTAS (Advanced Circuit Breaker Test and Analysis Systems) instrumentation.
Force tester
08 April, 2009 | Supplied by: Royce Water Technologies Pty Ltd
The Chatillon TCD225 force-testing system can be set up in seconds to perform a wide variety of tests. It allows users to perform singular or multi-variable testing without relying on a personal computer or complex software.
AC servomotors
08 April, 2009 | Supplied by: M Rutty & Co Pty Ltd
The Mavilor MA series of AC servomotors provides a short mechanical time constant suitable for control operations.
Inline viscometers
08 April, 2009 | Supplied by: Rheology Solutions Pty Ltd
The Marimex range of ViscoScopes provides maintenance-free viscosity measurement for inline applications.
Reagent reservoir
08 April, 2009 | Supplied by: Lomb Scientific (Aust) Pty Ltd
The V-shaped wells of the Scienceware 12 Channel Reagent Reservoir allow complete sample withdrawal and minimise the waste of reagents. Each channel holds up to 5 mL and is numbered to facilitate serial dilution.
Permeable membrane cap
08 April, 2009 | Supplied by: SCHOTT Australia Pty Ltd
The Schott Duran permeable membrane cap can release gases to relieve pressure in a sealed bottle.
Electrode management system
08 April, 2009 | Supplied by: Endress+Hauser Australia Pty Ltd
The Memobase electrode management system provides users insight into the reliability, performance, estimated lifetime and early-warning-failure of pH electrodes.
Ohaus Pioneer Series analytical balances
08 April, 2009 | Supplied by: Bacto Laboratories Pty Ltd
The Ohaus Pioneer Series of analytical and precision balances are designed for basic routine weighing in a variety of laboratory, industrial and education applications.
Miniature motor
08 April, 2009 | Supplied by: ERNTEC Pty Ltd
The ADM 0620 is a miniature two-phase stepper motor with a 6 mm outer diameter, is 9.3 mm long, weighs 1.4 g and provides a high power-to-volume ratio.
Electroporation electrodes
08 April, 2009 | Supplied by: SDR Scientific
The Platinum Tweezertrode electrodes from BTX are designed to enhance in utero or in vivo transfection applications.
Gas sample cylinder
08 April, 2009 | Supplied by: Duff & Macintosh
Sentry’s sample cylinder allows gas samples to be collected at pressure, assuring that the sample constituents that can change state with pressure reduction are not lost during sample collection. An example of this type of sample would be LPG or other two-phase fluids that could flash off sample constituents if the pressure was reduced.
Temperature monitor
08 April, 2009 | Supplied by: SDR Scientific
The TM-3 Three-Scale Thermistor Temperature Monitor is designed for accurate temperature measurement. It is a portable thermometer that features celsius, fahrenheit and kelvin scales in a large, easy-to-read display.
Flip-top sample tubes
08 April, 2009 | Supplied by: Bacto Laboratories Pty Ltd
The BD Falcon 50 ml polypropylene conical tube with flip-top cap is suitable for any research applications requiring one-handed operations to open and close the cap.
Stirring bar multi-pack
08 April, 2009 | Supplied by: VWR International Pty Ltd
The Spinpak Assortment with Spinbar Restrainer offers octagonal magnetic stirring bars in 12.5, 25.5, 38 and 51 mm lengths in either a 3.2 or 8 mm diameter.
Microcentrifuge
08 April, 2009 | Supplied by: Eppendorf South Pacific Pty Ltd
The 30-place microcentrifuge 5430 line provides a range of options, including eight different rotors, tubes from 0.2 to 50 mL, microtest plates, deepwell plates and slides.
